CCENT Quiz 2: 10-Question Networking Practice Quiz
Take an untimed 10-question CCENT practice quiz, pause and return later, then review your selected answers after submission.
About this CCENT practice quiz
This is the second CCENT practice quiz. It contains 10 multiple-choice questions for learners reviewing entry-level networking material. The quiz is intended as a self-assessment and does not claim to cover any specific networking domain.
A multiple-choice question presents several possible answers. Select one answer for each question.
How to take the quiz
- Select Start quiz to begin with question 1.
- Choose one answer for each question.
- The quiz is untimed, so no countdown timer is imposed.
- You may leave the quiz and return later to continue.
- After answering question 10, select Submit quiz.
- Use the answer-review area to see the responses you selected. Correctness feedback is not displayed here because no answer key and supporting instructional material are provided.
Questions
Select one answer for each multiple-choice question.
Question 1
Which device is commonly used to connect multiple devices within the same local network?
Question 2
Which identifier is normally used to identify a network interface at the Internet Protocol layer?
Question 3
What is the primary purpose of a network protocol?
- A. To define rules for communication
- B. To increase monitor brightness
- C. To store physical cables
- D. To replace all network hardware
Question 4
Which term describes a network limited to a relatively small area such as a home, office, or building?
Question 5
What does a default gateway generally provide for a host?
- A. A path to networks outside the local network
- B. A replacement keyboard layout
- C. A method for cooling the processor
- D. A local file backup
Question 6
Which network service commonly translates a domain name into an IP address?
Question 7
What is the main purpose of a subnet mask or prefix length?
- A. To distinguish the network portion from the host portion of an address
- B. To encrypt every application message
- C. To identify a monitor model
- D. To measure cable weight
Question 8
Which test is commonly used to check whether a destination responds across an IP network?
Question 9
What does full-duplex communication allow on a link?
- A. Sending and receiving at the same time
- B. Sending only when the link is disconnected
- C. Receiving without using a network interface
- D. Preventing all traffic on the link
Question 10
Which action should a learner take after choosing an answer for the final question?
- A. Submit the quiz
- B. Remove every previous response
- C. Start a different operating system
- D. Disconnect the network immediately
Answer review
After submission, open the answer-review area to revisit the response selected for each of the 10 questions. Review shows your selected responses. No correct-answer feedback is provided in this assessment because an answer key and supporting instructional material are unavailable.
Common questions about the quiz
Is there a countdown timer?
No. This is an untimed quiz, so you can work at your own pace.
Can I stop before finishing?
Yes. You may leave and return later to continue the quiz.
Where can I find my responses?
Submit the final question, then open the answer-review area to revisit your selected responses.